hawkwrench Posted December 6, 2014 Share Posted December 6, 2014 what size square styrene tubing do you use to build the FRIES bar in and then what size styrene rod would you use for the extension rods? Thanks! Tim Quote Link to post Share on other sites
HeavyArty Posted December 6, 2014 Share Posted December 6, 2014 I think I used 3/32 tubing for the rods and 1/8 square stock for the center support on mine. Quote Link to post Share on other sites
hawkwrench Posted December 6, 2014 Author Share Posted December 6, 2014 Thanks Gino, I figured you would know. I almost pm'd you over it, but figured I'd ask as a new topic. This will make it easier for someone to make theirs with. Tim Quote Link to post Share on other sites
Dadeo911 Posted December 7, 2014 Share Posted December 7, 2014 Thanks Gino, I figured you would know. I almost pm'd you over it, but figured I'd ask as a new topic. This will make it easier for someone to make theirs with. Tim Yes it will. Thanks guys. Chris Quote Link to post Share on other sites
Rotorman Posted December 8, 2014 Share Posted December 8, 2014 I think I used 3/32 tubing for the rods and 1/8 square stock for the center support on mine. Did u get your kit then? Quote Link to post Share on other sites
Rotorman Posted December 8, 2014 Share Posted December 8, 2014 I think I used 3/32 tubing for the rods and 1/8 square stock for the center support on mine. Did u get your kit then? Quote Link to post Share on other sites
HeavyArty Posted December 8, 2014 Share Posted December 8, 2014 Did u get your kit then? I did, last week. This is not it though, but from my MH-60L DAP I did a few years ago. Quote Link to post Share on other sites
Rotorman Posted December 8, 2014 Share Posted December 8, 2014 I did, last week. This is not it though, but from my MH-60L DAP I did a few years ago. ok. did u start on the Seahawk yet.? Quote Link to post Share on other sites
HeavyArty Posted December 8, 2014 Share Posted December 8, 2014 Not yet. I probably won't get to it until after Christmas. I have a couple others to finish up first. Quote Link to post Share on other sites
Dadeo911 Posted December 10, 2014 Share Posted December 10, 2014 Not yet. I probably won't get to it until after Christmas. I have a couple others to finish up first. Hey Gino, Perhaps there will be presents that will go with your new acquisition. I heard recently from a friend "I'm not above plagiarism". I agree and look forward to being able to use your techniques. :-) Merry Christmas, Chris Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.